Before GPS, sailors found their position from three kinds of information. The first was how far they had travelled and in which direction, known as dead reckoning. The second was how far north or south they were, which they could measure from the sun and stars. The third was what the charts and written sailing directions said about the coast. Longitude, the east–west position, was much harder to measure and was not solved reliably at sea until the marine chronometer.
The two problems: latitude and longitude
Latitude, north–south position, can be found from the height of the sun or the Pole Star above the horizon. Navigators could sail north or south to a known latitude and then turn to reach a coast.
Longitude, east–west position, requires knowing the time at a reference place and comparing it with local time. Without a reliable clock at sea, navigators could not measure it directly. Their estimates depended on dead reckoning, and those estimates could be badly wrong after a long voyage.
Dead reckoning: the method behind most voyages
Dead reckoning starts from a known position and adds the distance and direction travelled since then. The navigator needed three things: heading from the compass, speed, and the time elapsed. Each watch, the navigator recorded these in a log and plotted the course on a chart.
Errors built up over time. Currents, leeway (sideways drift) and mistakes in speed estimates could move a ship well off course. Experienced pilots corrected their estimates when they sighted land, took sun or star readings, or found the depth with a lead line.
Measuring speed and depth
Speed was first judged by timing a floating object as it passed the length of the ship. The chip log, a line knotted at regular intervals and weighted to drag in the water, was in use by the 1500s. Sailors threw it over the stern and counted the knots that ran out during a timed interval, which gave the speed. The timing was done with a sandglass, usually a half-hour glass.
The lead line measured depth. It was a rope with a lead weight at the end, and the lead’s base could be coated with tallow to bring up sand or shell from the seabed. Those samples helped sailors judge where they were near the coast.
The compass
The magnetic compass was used for navigation in Europe by the late 1100s. The English writer Alexander Neckham is often cited as one of the first Europeans to describe a compass used at sea. Early sea compasses floated a magnetized needle on a piece of wood, and later the needle was fixed to a card marked with the wind rose.
The compass gave a heading when the sun and stars were hidden, which made it essential for dead reckoning.
Measuring latitude: astrolabe, quadrant and cross-staff
The height of a celestial body above the horizon gives latitude. In the Northern Hemisphere the Pole Star stays nearly fixed in the sky, and its height above the horizon is close to the observer’s latitude. In both hemispheres, the height of the midday sun, combined with its declination from tables, gives latitude.
Several instruments measured that height:
- The mariner’s astrolabe was a brass instrument with a sighting arm that was held up to the sun or a star. It was a simpler and sturdier version of the scientific astrolabe, designed to be used at sea.
- The quadrant was a quarter-circle with a sighting vane and a plumb line. It could measure altitudes up to 90 degrees.
- The cross-staff, known in Portuguese as the balestilha, was a long staff with a sliding crosspiece. The navigator aligned the crosspiece’s end with the horizon and its other end with a star or the sun.
These instruments needed a steady hand and a clear horizon, and at sea the readings were often rough.
The back-staff and the sextant
Looking straight at the sun through a cross-staff could damage the eyes. The back-staff, developed by the English navigator John Davis in the 1590s, let the navigator stand with his back to the sun and measure its height from the shadow of a vane.
The sextant came later. It was developed in the early 1730s, independently, by John Hadley in England and Thomas Godfrey in America. It measured angles with mirrors, which gave more accurate readings than earlier instruments and could also be used on a moving deck.
Charts and pilot books
Early navigators relied on written sailing directions, known as rutters or, in Portuguese, roteiros. These described coasts, landmarks, currents, depths and anchorages. Pilots added to them after each voyage.
Portolan charts, widely used from the late 1200s, showed coastlines with rhumb lines radiating from a compass rose. They helped navigators plan a course, though they did not show longitude accurately. Portuguese charts improved through the 1400s as coastal explorers added information from each voyage.
Wind, currents and the volta do mar
Portuguese navigators used a technique called the volta do mar, or turn of the sea, to get back home from the Atlantic. Rather than beating back along the African coast against the wind, ships sailed far out into the open ocean to pick up the westerly winds, then turned east toward Iberia. Historians discuss the exact details of the technique, but it is well described in Portuguese sources.
Longitude and the marine chronometer
Finding longitude needs an accurate clock. The solution was a marine chronometer, a precise timekeeper that could keep time at sea despite motion, temperature and humidity changes. John Harrison’s H4 was tested on a voyage to Jamaica in 1761 and 1762, and it kept time closely enough to fix longitude with good accuracy.
Captain James Cook’s second voyage, from 1772 to 1775, carried a copy of H4 made by Larcum Kendall, known as K1. By then the chronometer was becoming part of ordinary navigation at sea.
What this means today
GPS has replaced these methods for most ships, but the logic has not changed. Dead reckoning is still taught and used as a backup, and the basic idea of combining speed, heading and time with a fixed reference remains central to navigation. For the ships that carried these instruments, see the ships of the Age of Exploration. For navigation on the first circumnavigation, see the Victoria.